I found the following diagram that seems to be what i am looking for in order to hook the fan up to the arduino.
Arduino pwm fan control.
The temperature and fan speed are reported through a 8 digit 7 segment display fitted on a rack mounted aluminium bar.
However i am looking at controlling the fan speed with the arduino via the pwm pins.
I have been wondering about this project and how to control my 4 pin pwm fans.
Many projects that use a temp sensor but never the most simple thing.
The microcontroller controls the speed of an electric fan according to the requirement allows dynamic and faster control and the lcd makes the system user friendly.
The arduino throttles the fans using pid logic and drives them through pwm.
In this post we have described how to design temperature based fan speed control monitoring with arduino and lm35 temperature sensor.
Controlling the fan was seemingly straightforward.
Temperature based fan speed control monitoring with arduino.
The problem was that the hall effect sensor or tach signal was incredibly noisy.
I had 5 laying around and thought mine as well give it a shot.
Beginner full instructions provided 24 154.
The system uses a temperature sensor to control four fans that are driven by an arduino controller.
Control pwm fans with an arduino some basic c programming and a lot of fun.
The ultimate project is to control the fan based on temperature.
The noise made it impossible to measure the fan s rotation.
I am looking at getting 2 80x10mm pwm fans.
The frequency values can be adjusted between 125 hz 8 mhz as well as a variable duty cycle.
The blue led seen on the prototype board is just for verifying correct circuit operation and also can be removed.
There is some information out there.
I o pin 9 on the arduino board is directly connected to fan control input and by reading the state of 3 push buttons on pins 2 3 4 different pwm values are sent to the fan.
The circuit utilizes the mode 10 pwm phase correct on timer 1 ocr1a pin 9 and icr1 pin 10.
A question came up on irc regarding how to pwm a 3 pin pc fan with an arduino using analogwrite.
I simply want to control a 4 wired fan or maybe several with an arduino board.
Control the speed of the fan.